Jim
New Member
Posts: 36
|
Post by Jim on Aug 3, 2011 16:17:12 GMT -5
I've been using a Bosch Colt for several months on my WD1 and have encountered a problem with the router.
When changing bits the push button that holds the shaft in position to open the collet with the wrench is slipping. Sometimes I have to try numerous times before it will actually hold.
Has anyone encountered this problem. I'm assuming I may have been tightening the bits to tight and causing the problem myself.
Can I replace any parts to solve the problem. Any information would be greatly appreciated.
LAMEIII
|
|
|
Post by georgemyers on Aug 3, 2011 22:40:25 GMT -5
Never owned a Colt but out of about a dozen dremel drills I have had over the past 30 years I had this happen to all of them. Maybe check to see if there is a rebuild kit for the Colt, my guess is your is not the first one that this happened too.
|
|