buddy
New Member
Posts: 1
|
Post by buddy on Jul 21, 2022 5:57:37 GMT -5
I bought the machine used it’s got the 201x gecko drivers. The previous owner sent me several xml files but still no luck have green and blue steady lights on UC100, green lights on drivers. Y axis won’t move, Z will only go down unless I reverse it in settings. X axis is all the way against limit switch on left side won’t move to the right. Any keyboard key I use moves X and Z the same direction. I hit the tab button to bring up jog it’s the same way. Only moves Z and X the same way and nothing on Y. Machine is 24x36. All wiring connections feel and screws are tight. I download WD1 xml from Romaxx site still done the same like the files sent by the previous owner. I did have to change the Estop to 15 from 10 to get it to reset and the motors jarred on the X and Z for sure couldn’t tell if the Y was powering up. Previous owner has two of these machines and I know there built with quality parts I’m just missing something is all. It’s been over a decade since I’ve used MACH 3 or even tinkered with it. I have the red in color 201 X drives not sure if that helps. I don’t know much else. My email that I use the most is csmoak25@yahoo.com. Any help would be greatly appreciated
|
|