flhtc
New Member
Posts: 1
|
Post by flhtc on Jul 6, 2023 15:46:21 GMT -5
I purchased a HS1 in 2009 and it has been working fine until recently. My computer that I was using stopped working and I wanted to upgrade to a laptop with Windows 11 so I purchased a UC 100 so I could use the USB port. I installed it and both lights are on (green and blue) Mach 3 works fine and will run a carving file start to finish but the HS1 won't do anything. The yellow power light is on and all fuses are good. This machine has not been used for about two years and might have been exposed to freezing temps. Are their any troubleshooting guides for the electronics or can anyone give me some suggestions on what might be wrong. Also when everything is powered up I can manually push all axis XY and Z.
|
|