|
|
Post by rlk6166 on Oct 13, 2012 11:32:32 GMT -5
Came across this site and it seems to be something I would be interested in. From the comments on this site, it sounds like individuals are pretty well satisfied. Is there anyone in the area where I would be able to view this machine? I am interested in the WD-1 Machine. I am located in LaPorte, Indiana. I do have a machine that was converted to a CNC. It works okay, but the tolerance factor is not the greatest.
Hoping to hear from someone.
|
|
|
|
Post by brucemoore on Oct 23, 2012 14:14:29 GMT -5
Bloomington? Not NW but Indiana if you feel like driving a little.
|
|
|
|
Post by rlk6166 on Oct 31, 2012 19:06:33 GMT -5
Bruce, thanks for the invite. There seem to be quite a few happy CNC'ers on the site. I mean happy with regards to support and the overall operation of the machine. So, rather then drive to Bloomington, I just sent Ron a check for a WD-1 machine. Now it's anticipation time. I hope to be a participant on this site.
Thank's again for the invite.
Bob
|
|
|
|
Post by brucemoore on Nov 1, 2012 10:45:03 GMT -5
You will like it. The only advice I have on a new machine other than have fun is to watch the bearings. Keep em clean and oiled. The dust these things generate takes a lot out of the bearings.
(Sent you a PM)
Bruce
|
|
|
|
Post by rlk6166 on Nov 4, 2012 16:30:45 GMT -5
I should have informed you that I sent a PM. Did not want to give my personal information. On vacation right now but would still like to make a trip to Bloomington to talk CNC.
Bob
|
|
