Post by maxxfactor on Apr 6, 2014 0:01:35 GMT -5
Has anyone experienced the Y motors bogging down to a crawl while jogging the gantry toward one end of the table? It's the front panel end.
It's almost as if the V bearings are getting tight on the rails or something. The machine is new and I've only jogged the XYZ back and fourth a couple times when I noticed this. Have not attempted any adjustments yet. Any help would be greatly appreciated.
It's almost as if the V bearings are getting tight on the rails or something. The machine is new and I've only jogged the XYZ back and fourth a couple times when I noticed this. Have not attempted any adjustments yet. Any help would be greatly appreciated.