|
Post by bob333 on Sept 7, 2014 15:34:52 GMT -5
hello all am making slow but steady progress, really liking the machine and its capabilities. does anyone out there have a good macro for a simple tool change, have watched video on mach support page but am getting syntax errors when I test the code.
|
|
|
Post by georgemyers on Apr 17, 2015 22:08:03 GMT -5
What type of control software do you use. I use Mach3 and everytime I change bits (new toolpath) I just thange the bit at the home position. Or do you have a ATC. I'll go on the mach site to see if I can see what video you are watching.
|
|