ronb
New Member
Posts: 4 
|
Post by ronb on Nov 15, 2015 19:59:51 GMT -5
Has anyone tried using Linux CNC to control a HS-1? I was hoping to find someone with experience and a config file to share. I'm new to CNC and have not plugged in my HS-1 yet.
RonB
|
|
|
|
Post by georgemyers on Dec 4, 2015 13:35:29 GMT -5
Can't help on Linux CNC but below might give you a good start. (most likely I too late in replying to your post to be of any help) You most likely already seen this, but it give some basic steps on setting up Linux CNC. buildyourcnc.com/Item/control-SOFTWARE-linuxcncAlso check on youtube, I seem to remember seeing videos on EMC/Linux cnc. Hope you are up and running, the HS1 is a very nice machine. It is one thing I have bought that I never regretted. |
|
|
|
Post by romaxxcnc on Dec 1, 2016 14:05:38 GMT -5
Linux CNC EMC is just another PC based control software issuing a step and direction signal. Yes any of our machines will work in a Linux EMC environment, and other software too.
Thanks, Ron
|
|
