|
Post by woodogre on Oct 10, 2016 19:32:59 GMT -5
I just finished up some long runs with my WD1. Now I've noticed unfamiliar sounds from under the table. Looking into it I can see my belt jumping on the pulley's when I jog in Y. Any ideas what's going on. Thanks, WO
|
|
|
Post by halzucati on Oct 16, 2016 4:29:59 GMT -5
I had the same problem with my X-axis and it turned out that the belt was catching on a bolt head... check the belt tension and make sure that its not catching in something.
|
|
|
Post by georgemyers on Nov 10, 2016 21:42:54 GMT -5
I also had the problem. My was due to a section of the belt was stretched. The belt was not the original one on the router, I had bought this belt local and it did not have steel strands in it.
|
|
|
Post by romaxxcnc on Dec 1, 2016 14:00:58 GMT -5
The belt appearing to be loose means it was probably out of adjustment. There are other issues that can cause that. Best thing to in that instance, is give us a call. 313-937-8194
Thanks, Ron
|
|