Bearings for romaxx HS-1 older model

new

« Prev
1
Next »

firefight100
New Member

Posts: 5

Bearings for romaxx HS-1 older model Oct 25, 2018 21:20:50 GMT -5

Quote

Post by firefight100 on Oct 25, 2018 21:20:50 GMT -5

I have had my wd1 here in Florida for about 6 years. In the humidity here, the case started to rust since it is not painted. I cleaned it up and coated it with auto wax and left it on.
Also my bearings all appeared to not have any lube in them. I took each one, removed the dust seal and packed them with grease. Reinstalled the seals.
Also remove the drawer and vacum it out once in a while.
Overall it seems a good machine.

firefight100
New Member

Posts: 5

Bearings for romaxx HS-1 older model Oct 29, 2018 6:50:13 GMT -5

Quote

Post by firefight100 on Oct 29, 2018 6:50:13 GMT -5

yes they are easy to remove. Just use a small knife or screwdriver slipped in the inner diameter of the seal and they will pop out. Clean the bearing and pack with good grease and you can pp the seals back in. I didnt look to see what brand they are. Ron @ Romax will sell new bearings if any are shot.