Post by rfsign on Jan 8, 2019 19:04:12 GMT -5
Z axis does not make contact with material when running code
Machine is WD-1
Windows XP
Mach 3 2010 Screen Set
Touch plate
Machine was working great. Had to hit stop while running a file and the z access went up and crashed before I could hit the red button. After that everything I run the z always is approximately a 1/16" above my substrate (not cutting in to the material)
Things I have tried...
Turning on and off the machine and the computer
wrote new code
checked to make sure there were no shorts between the driver and the motor
Machine is WD-1
Windows XP
Mach 3 2010 Screen Set
Touch plate
Machine was working great. Had to hit stop while running a file and the z access went up and crashed before I could hit the red button. After that everything I run the z always is approximately a 1/16" above my substrate (not cutting in to the material)
Things I have tried...
Turning on and off the machine and the computer
wrote new code
checked to make sure there were no shorts between the driver and the motor
