deadright
New Member
The R4 relay on the quad relay board led is not lit and no power is getting to drives. How do I ve
Posts: 1
|
Post by deadright on Apr 18, 2021 12:07:27 GMT -5
I have installed the UC100, both green and blue led's are lighted. This indicates communication with Mach3 and the UC100. Jogging the keyboard changes the appropriate DRO as if the axis was moving, but the axes are not energized . You can still turn them by hand. I have installed the UC100 software and Mach3 on 2 different computers using the automatic install on both and neither are communicating with stepper drivers or even powering up the motors to lock them. Tried both Win7 64 bit and Win 10 64 bit both of which are supported with my current download of software.
Appreciate any thoughts or suggestions. I will check fuses but it was still running(some what erratically) on the printer port set up.
|
|